Apologies for reposting about the same problem but had no replies so changed thread heading to hope for better response
Since fitting a dawes device to my 93 wrx I have had a hesitation as i come on revs (no problem after) I am not 100% sure that the pipework involved in fitting device is correct, could somebody possibly look at pics in my scooby to check against theirs or own knowledge
Many many thanks in advance

 

Looks to be ok, although i can't see where the pipe from the 'bent' end goes.... it should go straight to the actuator..... also, i was told that they work better if they're upright, ie, the straight inlet being upright, not laid over as you have it.... don;t know if it'd really make a difference, but it might.....

 

Many thanks Ron, I will try it upright as suggested.

 

 

Thanks Slipstream for pic
As it was a nice day yesterday I took various bits off and discovered a small hole in pipe right next to turbo inlet nipple so cut it out and all seems well now.
Obviously I should have checked first but very much appreciate all your help
Jon