AVCR Install Quick Question
#1
Scooby Regular
Thread Starter
AVCR Install Quick Question
Hi,
Just a quick question on the AVCR.
Am fitting one today in preparation for it to be setup by Jolly Green Monster in a few weeks time.
Am doing most of the leg work beforehand to make it easier.
Now then, can we connect some (or all) of the wires into the ECU, so the unit fires up and displays, but obviously NOT connecting anything in the engine bay.
Thanks.
Just a quick question on the AVCR.
Am fitting one today in preparation for it to be setup by Jolly Green Monster in a few weeks time.
Am doing most of the leg work beforehand to make it easier.
Now then, can we connect some (or all) of the wires into the ECU, so the unit fires up and displays, but obviously NOT connecting anything in the engine bay.
Thanks.
#2
Scooby Regular
Join Date: Jul 2000
Location: Lancashire
Posts: 2,209
Likes: 0
Received 0 Likes
on
0 Posts
You can connect all the wiring and install the MAP sensor and solenoid in their correct locations, you can also plumb in the MAP sensor but leave the solenoid plumbing for Simon.
Andrew...
Andrew...
#3
Scooby Regular
Thread Starter
Thanks Andrew,
On a Newage STI, where does the Apexi Map sensor need to be fitted.
I've read some posts saying tee into the dump valve pipe (I also have my boost gauge tee'd in there)
and other posts say tee into the front of the inlet manifold....
confused....
Any advice ?
On a Newage STI, where does the Apexi Map sensor need to be fitted.
I've read some posts saying tee into the dump valve pipe (I also have my boost gauge tee'd in there)
and other posts say tee into the front of the inlet manifold....
confused....
Any advice ?
#4
#5
Scooby Regular
Thread Starter
Thanks Simon, I know where to tap it from now
Have done all the wiring to the ECU.
Have noticed that the speed reads in KPH not MPH. Is this just because its a jap product ?
Have done all the wiring to the ECU.
Have noticed that the speed reads in KPH not MPH. Is this just because its a jap product ?
#7
Scooby Regular
Thread Starter
My car reads in mph. However the avcr display is reading the correct kph.
ie 60kph on the display and I'm doing 40ish mph.
ie 60kph on the display and I'm doing 40ish mph.
Trending Topics
#8
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
yeah unfortunatly it is not switchable to mph.. although I guess if you really wanted to you could fit an electronic converter to the feed wire.
Simon
Simon
#12
Scooby Regular
Thread Starter
No big deal, was only curious. I'll set the display to show something else
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM