Notices

Error codes 11,12,22

Thread Tools
 
Search this Thread
 
Old 08 October 2006, 11:10 PM
  #1  
Postman Pat
Scooby Regular
Thread Starter
 
Postman Pat's Avatar
 
Join Date: Dec 2001
Posts: 297
Likes: 0
Received 0 Likes on 0 Posts
Question Error codes 11,12,22

MY99 UK turbo.(bog std no mods)

Above codes have come up. The check engine light illuminates at low revs only (so far). I have reset the ECU but they came back after a bit of driving. Car seems to be running ok with maybe a little bit of a lumpy idle when cold.
Code 11 - crankshaft position sensor
Code 12 - starter switch
Code 22 - knock sensor

I'm not a big believer in co-incidences so I reckon there must be a common link somewhere but reading through the diagnostic stuff I have doesn't throw any light in my direction.

Has anybody have any experience of these? Any advice would be mucho appreciated

Thanks Pat
Old 10 October 2006, 12:58 PM
  #2  
Postman Pat
Scooby Regular
Thread Starter
 
Postman Pat's Avatar
 
Join Date: Dec 2001
Posts: 297
Likes: 0
Received 0 Likes on 0 Posts
Default

bttt
Old 10 October 2006, 04:15 PM
  #3  
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Jolly Green Monster's Avatar
 
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes on 2 Posts
Default

possibly an earthing problem.. check the earth connection on the inlet manifold just in front of the intercooler.. to the right of the coil pack..

also worth running a new wire from battery negative to the block and to the body work to see if it helps..

Simon
Old 10 October 2006, 11:07 PM
  #4  
Postman Pat
Scooby Regular
Thread Starter
 
Postman Pat's Avatar
 
Join Date: Dec 2001
Posts: 297
Likes: 0
Received 0 Likes on 0 Posts
Default

Thanks Simon I'll give that a go in the next few days.

Pat
Old 11 October 2006, 11:13 AM
  #5  
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Jolly Green Monster's Avatar
 
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes on 2 Posts
Default

jump leads work as a quick check..
Old 03 November 2006, 03:28 PM
  #6  
Postman Pat
Scooby Regular
Thread Starter
 
Postman Pat's Avatar
 
Join Date: Dec 2001
Posts: 297
Likes: 0
Received 0 Likes on 0 Posts
Default

Simon
Cleaned the earth's. Car's working a treat (hasn't been this smooth in months).
THANKS AGAIN

Pat
Old 03 November 2006, 11:12 PM
  #7  
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Jolly Green Monster's Avatar
 
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes on 2 Posts
Default

Ace

Simon
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Darrell@Scoobyworx
Trader Announcements
26
30 January 2024 01:27 PM
Abx
Subaru
22
09 January 2016 05:42 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Nick_Cat
Computer & Technology Related
2
26 September 2015 08:00 AM



Quick Reply: Error codes 11,12,22



All times are GMT +1. The time now is 08:00 AM.