could any1 please tell me wot my car would roughly produce with these mods
full decat(TSL downpipe,magnex centre,magnex backbox)
k+n panel filter
scoobyecu(16.4 psi)

car made 224bhp 200 torque last time on the rollers
that was with just the filter and backbox
its a my94 uk wagon

thx

steve

 

260?

 

249Bhp and 230 torque
Just a guess - are you gonna get it on the rollers?

 

I would be very interested to know as I have the same car with nearly the same mods except it's a JDM wagon with a TD04 instead of your TD05:

MY94 Wagon
Magnez down pipe and decat centre
STi Back-box
VOS chip (16psi)

I suspect you will have more top end and I will have more low down grunt.

Perhaps 260BHp and 230 ft/lb torque for you
and 250BHp and 240 ft/lb for me

 

What about bhp/torque for a STANDARD 1992 jap import WRX?

Cheers
Luke

 

240bhp/230lbft there or thereabouts for such an early import

 

Ok cheers mate

 

Full 3" exhaust? Anything over 245 bhp and similar torque is a bonus.
Standard 92 WRX around 210-220bhp.

 

yah peeps get mixed up with ps and bhp the book does say 240 for a early wrx but this is measured in ps and is acheived with 100 ron juice

 

my zorst is a tsl 3 inch dp
going into magnex centre and bb
think its 2 and a quarter pipe
wot would you have to do to get near 300 brake out of a uk wagon

steve

 

if its magnex it wil be 2.1/2" (75mm) try some cheating juice 50 shot should do the trick

 

im no mechanic but the upping the boost is whats needed but this can be pretty dangerous if precautions arent taken. gueges knocklinc etc and iirc anything over 1.1bar ur going to need a fmic

 

i run well over 1.1 bar i only have a TMIC

 

94 version 1 STI import

full exhaust with open neck down pipe
255lph fuel pump
apexi air filter
ap organic clutch with l&b flywheel
unknown make of blow off valve

what do you reckon?

 

Any ideas peeps?

 

pretty sure your car comes with 250(ps)


standard, u should get 10-15bhp from the downpipe maybe 3bhp from the fw, you do the math

 

My MY95 WRX without scoobyECU and has a CAT fitted made 262bhp. Only mods are cat back blitz nur spec exhaust, blitz air filter and dawes set to 13psi.

You should get more than this with the scoobyECU.

Dan