Help. New engine in but will not hold idle?
#1
Scooby Regular
Thread Starter
Join Date: Jan 2003
Location: Isle of Man
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
Help. New engine in but will not hold idle?
Just put a replacement engine in a 95 wrx, car fires and holds idle for about 15secs then dies.
If throttle is touched it dies to, we suspect the MAF but it was running with the old engine the day before swap.
However it may have had a knock when working on car.
We did get an error code 23, which is MAF, but did ecu reset and it has not come back but still have same problem.
Anybody any ideas?
If throttle is touched it dies to, we suspect the MAF but it was running with the old engine the day before swap.
However it may have had a knock when working on car.
We did get an error code 23, which is MAF, but did ecu reset and it has not come back but still have same problem.
Anybody any ideas?
#3
Scooby Regular
Join Date: Mar 2004
Location: N Wales
Posts: 194
Likes: 0
Received 0 Likes
on
0 Posts
CHECK MANIFOLD FOR ANY LEAKS, GASKETS, VAC PIPES, THROTTLE BODY. THE FAULT COULD STILL BE WITH THE MAF BUT IF IT ONLY RUNS FOR 15 SECS THE ECU DOESNT GET TIME TO LOG THE FAULT AS IT HAS TO OCCUR FOR A CERTAIN PERIOD BEFORE DOING SO.
Thread
Thread Starter
Forum
Replies
Last Post
supshon
General Technical
2
03 October 2015 08:06 PM