Is a Unichip a good solution for MY98 Map ?
#4
I cannot say enough good things about the Unichip so feel free to mail me off list if you want specifics.
I have run Unichips on my last 3 cars over 5 years and always been overwhelmed with the results.
As with any map, its only as good as the technician doing the mapping.
If you are running anywhere up to around 320-340bhp I would strongly recommend this as the best value for money solution at around £550.00 , mapped with EBC and 30 money back gaurantee.
Wheres Deep Singh????? LOL............
I have run Unichips on my last 3 cars over 5 years and always been overwhelmed with the results.
As with any map, its only as good as the technician doing the mapping.
If you are running anywhere up to around 320-340bhp I would strongly recommend this as the best value for money solution at around £550.00 , mapped with EBC and 30 money back gaurantee.
Wheres Deep Singh????? LOL............
#5
Mark,
I ran my last car an MY00 for 60,000 on a Unichip and achieved pretty good results.You can still see them on dyno scooby.
With a decat system and not much else it made 273bhp and 250lbft.
Had it done at Powerstation.
Also ran my STi7 02 for about 30,000 on a Unichip and for what I wanted at the time it serve it purpose well( also fitted at Powerstation).Have now upgraded to a TEK3(loads of thanks to Pat & Merv) as I have carried out some further mods.
The one disadvantage with the last car was the poor boost control, if not used in conjunction with some control unit.You can now get a boost control unit made by Dastek that works with the Unichip.
Hope its some help.
Grant
I ran my last car an MY00 for 60,000 on a Unichip and achieved pretty good results.You can still see them on dyno scooby.
With a decat system and not much else it made 273bhp and 250lbft.
Had it done at Powerstation.
Also ran my STi7 02 for about 30,000 on a Unichip and for what I wanted at the time it serve it purpose well( also fitted at Powerstation).Have now upgraded to a TEK3(loads of thanks to Pat & Merv) as I have carried out some further mods.
The one disadvantage with the last car was the poor boost control, if not used in conjunction with some control unit.You can now get a boost control unit made by Dastek that works with the Unichip.
Hope its some help.
Grant
#6
Sorry forgot to say............ I would only recomend the following 2 places
Firstly the best people IMO.
Owen Developments.............www.owendevelopments.co.u k
or secondly
Powerstation , Cheltenham
who are also very good.
Firstly the best people IMO.
Owen Developments.............www.owendevelopments.co.u k
or secondly
Powerstation , Cheltenham
who are also very good.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM