inlet manifold removal and replace -GC8
#1
inlet manifold removal and replace -GC8
Hi technical lot.
I have a cleaned up and repainted inlet manifold that I would like to swap for my shabby and worn out one . I have looked around for guides but no exact one with images ( I like photos ) so using a combination of these guides
http://www.subaru-impreza.org/forum/...-manifold.html
http://ken-gilbert.com/wrx/STi_Manua...20Manifold.pdf
Question is : on a MY00 when removing it, is it worth replacing the gaskets at the same time just as a matter of good practice ?
Also whilst replacing , is it worth on a stock engine to pop in the manifold spacers or just leave as is ?
Finally I know it is a pig of a job but any good tips or tricks for a spanner numpty like me
I have a cleaned up and repainted inlet manifold that I would like to swap for my shabby and worn out one . I have looked around for guides but no exact one with images ( I like photos ) so using a combination of these guides
http://www.subaru-impreza.org/forum/...-manifold.html
http://ken-gilbert.com/wrx/STi_Manua...20Manifold.pdf
Question is : on a MY00 when removing it, is it worth replacing the gaskets at the same time just as a matter of good practice ?
Also whilst replacing , is it worth on a stock engine to pop in the manifold spacers or just leave as is ?
Finally I know it is a pig of a job but any good tips or tricks for a spanner numpty like me
Thread
Thread Starter
Forum
Replies
Last Post
Clarky79
Engine Management and ECU Remapping
14
13 August 2014 03:57 PM
swisstonihasher
General Technical
2
08 March 2011 08:04 PM
Prasius
General Technical
18
01 January 2009 02:59 PM