SAM-UK300

iTrader: (8)

Hi All,

Got my car mapped yesterday by Neil @ Slowboy racing, firstly just want to say how that Neil done an awesome Job and completely transformed the cars driving! excellent service and very helpful.

Drove fine yesterday, however today I gave it a good boot and went full whack and at high revs the CEL came up, plugged it in and it is a P0103 code which is high MAF input? didnt want to bother the mapper as thought maybe it was just a quick fix as it was fine yesterday? any ideas anyone?

Cheers
Sam

DT-SPD

iTrader: (7)

Think you need to go back to your mapper and have it redone

propofol

Had heard that MAF can't cope with higher bhp levels. Obviously don't know what your car is producing but may need to consider going MAFless.

SAM-UK300

iTrader: (8)

I am running VF35 at 1.45 bar and all the usuals, FMIC, 550's, 290 fuel pump, decat etc...

I'd guess 330-350bhp??

jura11

iTrader: (7)

Hi Sam

I would speak with Neil@Slowboy racing about this at first place

Can be the MAF is on way out or can be just Neil will needs to adjust the MAF

If you running Induction kit and this weather doesn't help too on MAF based cars,mainly if you are drive car to the puddle of water etc,due this I would speak first with Neil and from this I would go

Jura

Nevell

Hi old thread I have the exact same problem did you ever sort this ?

bludgod

iTrader: (3)

there is a MAF voltage limit in the ECU map. if someone by accident forgets to increase this limit then you'll get an error at high boost/high RPM combo when mapped. Should take the mapper only a few mins to reflash with an increased limit.

SAM-UK300

iTrader: (8)

+1 yup

Nevell

Cool beans over 300 bhp :-) had it mapped yesterday I'll have a word ,not dangerous then , just annoying

t4and greys

Check you havnt got a boost leak eg split boost pipe too

Nevell

All sorted :-)

t4and greys

Did you have map tweaked nevell ???
Only asking as have same issue myself at mo

Nevell

No mate I worked out it only comes on if I rev over 6500 rpm :-) and I done abit of research and it's just a built in warning for standard map saying there is to much air going past maf that's all, it's fine but annoying , but I will get it tweaked out , when I get a few other mods :-)