stedee

iTrader: (4)

ive just done an engine build, that works lol

i fitted a new exedy clutch and 2nd hand lightened flywheel

cant engage a gear at all and the pedal does feel light, ive took the slave cylinder off to feel the movement in the clutch fork, it just moves freely and makes a clicky noise at the end of its travel


ta

stonejedi

iTrader: (51)

alignment?

shepster

iTrader: (2)

Release bearing not engaged??

stedee

iTrader: (4)

--------------------------------------------------------------------------------
hi again
the clutch pedal feels light.ive checked the master cylinder - ok and i can see alot of good movement from the fork

someone has said to me about the flywheel being too thin is this true, i would have thought it would have slipped once in gear but it would have selected gears.

i did notice on the clutch pressure plate that when the thrust bearing was fitted, the ring it fits into as got alot of in/out movement aswell, i just thought this was normal but dont know now.
cheers

niktiler

iTrader: (5)

sounds like when u installed the clutch the bearing was not put in the fork corectly and has probably slipped out the fork

my94wrx

iTrader: (4)

as above, either the release bearing not located in the clutch cover properly or the fork not in the release bearing properly.