dawes device trouble
#1
i have a my98 uk scooby which used to boost at 0.75 as standard then i put a dawes device on and it would still only boost 0.75 but was a different car to drive it flies but uses loads of juice -80 miles = £20 quid knocking about so i thought i would take the dawes off and fit new pipes and t-piece as the old one snapped then the car would'nt even reach 0.50 bar. dissconected battery for 2 hours which did no good so i put dawes back on and still only goes 0.5 bar and feels slow please help. like driving escort td again.........no trouble until now
#3
err no i didnt but when i took the pipe off in the first place it cracked so i chucked it...but with the dawes back on it should be the same as before i took it off should'nt it i dont know anything about turbo's thanx 4 the info m8
#6
Scooby Regular
iTrader: (1)
Join Date: Mar 2002
Location: North East Subaru Forum
Posts: 3,920
Likes: 0
Received 0 Likes
on
0 Posts
not being funny but have you got it on the right way around???
the straight outlet end goes to the turbo outlet and the angled end goes to the actuator.
hope this helps!
the straight outlet end goes to the turbo outlet and the angled end goes to the actuator.
hope this helps!
Trending Topics
#8
bought new pipe with restrictor i found loads of cracks in my original now boosts 0.9 plus the restrictor was at an angle now it flies again but smoother than its ever been thanx 4 the info
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM