tek2 resettling
#1
Scooby Regular
Thread Starter
Join Date: Apr 2003
Location: worcs.
Posts: 321
Likes: 0
Received 0 Likes
on
0 Posts
hi, new to all this, good site.
just a question about a tek 2 remap.
after a tank of 95 ron i reset my MY00 ecu sucessfully, (using green and black wires under dash etc), couldn't really notice much of a difference acually, now runing only on optimax/SUL. my omly mod is magnex centre pipe and bb
considering a tek 2 upgrade, if i have to use 95 ron again and i then reset the ecu, will i lose the tek 2 benefits.
cheers i may be being a bit thick on this.
ps 18 months of very happy ownership and i've only just found scoobynet
just a question about a tek 2 remap.
after a tank of 95 ron i reset my MY00 ecu sucessfully, (using green and black wires under dash etc), couldn't really notice much of a difference acually, now runing only on optimax/SUL. my omly mod is magnex centre pipe and bb
considering a tek 2 upgrade, if i have to use 95 ron again and i then reset the ecu, will i lose the tek 2 benefits.
cheers i may be being a bit thick on this.
ps 18 months of very happy ownership and i've only just found scoobynet
#2
Scooby Regular
Join Date: Oct 1998
Location: Scoobysport, Basildon, UK
Posts: 4,300
Likes: 0
Received 0 Likes
on
0 Posts
All Ecutek maps are as permanent as the factory maps and cannot be erased by doing a reset. You will lose the ecu's correction table though and this will be rebuilt by the ecu, just as when the car was first used on the OE/Ecutek map.
Thread
Thread Starter
Forum
Replies
Last Post