Wastegate Guage......
04 February 2003, 06:06 PM
#1
Scooby Regular
Thread Starter
Join Date: Dec 2002
Posts: 329
Likes: 0
Received 0 Likes
on
0 Posts
Can you measure the pressure that the wastegate is operating at by fitting a guage similar to that for the boost ??
Also do people fit uprated Wastegates and if so what does anyone recommend ??
Also do people fit uprated Wastegates and if so what does anyone recommend ??
04 February 2003, 09:08 PM
#2
Scooby Regular
Join Date: Nov 2001
Location: Leeds - It was 562.4bhp@28psi on Optimax, How much closer to 600 with race fuel and a bigger turbo?
Posts: 15,239
Likes: 0
Received 1 Like
on
1 Post
If you want to know mail the supplier 
I use a compressor and regulator..
David
I use a compressor and regulator..
David
02 April 2003, 08:32 PM
#3
Scooby Regular
You can check your wastegate using a simple handheld pressure/vacuum pump like this
Apply pressure to the wastegate and when it pops open, it'll show you how much pressure it took to open.
Stefan
[Edited by ozzy - 2/4/2003 9:32:37 PM]
Apply pressure to the wastegate and when it pops open, it'll show you how much pressure it took to open.
Stefan
[Edited by ozzy - 2/4/2003 9:32:37 PM]
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
14
25 September 2015 02:33 PM