Looking For a Good Welder (Guildford Area)
30 September 2002, 11:59 AM
#1
Scooby Regular
Thread Starter
Join Date: Jul 2002
Posts: 1,933
Likes: 0
Received 0 Likes
on
0 Posts
Chaps
We need to get s small amount of welding done on the chassis of my wife's Mx5. The complication is the fuel and brake lines run alongside
Can anyone recommend a welder in the Guildford area?
Thanks in advance
Iain
We need to get s small amount of welding done on the chassis of my wife's Mx5. The complication is the fuel and brake lines run alongside
Can anyone recommend a welder in the Guildford area?
Thanks in advance
Iain
but someone out there must have used one on another car, surely?!?!?!?
04 October 2002, 03:59 PM
#3
Scooby Regular
Join Date: Feb 2002
Posts: 840
Likes: 0
Received 0 Likes
on
0 Posts
V5
You might try Mayford Motors (Mayford, near Woking/Worplesdon), they are only a very small garage but seen pretty competant, there's also a place about a mile away on a very small industrial estate, can't remember what they are called but can give directions, they did a top job on my RS1600i a few years back after I found out it was a cut and shut. Also GARTRAC in Godalming are good (but probably expensive).
Hope this helps
Ian
You might try Mayford Motors (Mayford, near Woking/Worplesdon), they are only a very small garage but seen pretty competant, there's also a place about a mile away on a very small industrial estate, can't remember what they are called but can give directions, they did a top job on my RS1600i a few years back after I found out it was a cut and shut. Also GARTRAC in Godalming are good (but probably expensive).
Hope this helps
Ian
Thread
Thread Starter
Forum
Replies
Last Post
Sambob
Engine Management and ECU Remapping
41
27 November 2015 07:36 PM
Adam Kindness
ScoobyNet General
0
15 September 2015 03:31 PM