Hi,
Just had my STI7 decat + ECUTEK down at PE to have it on the rolling road.

The figures I am getting are as follows:

335 BHP and 300LBS torque if that means anything to you lot.

 

Any other mods ?

 

Only other mod is an ITG panel filter.
Still have the reasonator inline in the exhaust thou.

 

David,they look like really good figures mate.According to those you've gained 70 BHP!!!!!!!!!

 

Deep ,
I tried ringing your mobile eralier but no answer.
I am trying to scan in the graph to post on here,, once I have the scan where do I put it???

Dave.

 

Right if you want to see my map here it is:

Actually John has posted it for me below as I didnt convert it properly.

Thanks John.




[Edited by mccltd - 1/16/2003 11:26:35 PM]

 

I converted it to a gif and hosted it for you the .bmp was hoooge

 

Thanks John..

What did you use to convert it????



[Edited by mccltd - 1/16/2003 11:25:39 PM]

[Edited by mccltd - 1/16/2003 11:27:15 PM]

 

Paint will do it, or something like Irfanview, or any image editing prog. Most put up a jpg for photos or subtle shading, screenshots etc. Dyno plots actually look better when converted to gif. I just choose the format when I "save as". Sorry don't want to tell you how to suck eggs if you are computer sort

Nice torque curve BTW

Put some 200, 250, 300 gridlines on and some 500 RPM gridlines to help with reading off those nice juicy figures

[Edited by john banks - 1/16/2003 11:36:40 PM]

 

Thanks for that.
I did try saving it as a different format but it seemed to grow rather than shrink.

Ohwell, cheers.

 

Excellent stuff....not bad figures for a top mount and standard induction imho


Is this a ScoobySport decat ? Do you still have the 1.25mm restrictor fix in or back to stock size restrictor ?

How many tries did it take to get a good result....was it just plug and play ?


I want 335 bhp and 300 ft. lbs

Cheers,
Ray

 

Hi Ray,
I'm using the Scoobysport rear , centre and downpipe but still have the reasonator in line.
To get the power by the remap it basically took 2 tries the first one was fine, but went back for a little tweak as two flat spots appeared.
They have now gone.

Da\/e.

 

Dave,

Superb!

Can't wait to tweak my boost soon, I'm only pulling 1.3bar at the moment.

Cheers

Paul

 

Dave

Pat said you were pretty happy, I can see why

Very impressive torque curve.

 

Pete,
I did leave a message with you yesterday after they did it with the figures.
Hope you got it.

Thanks for the work done on the car.

Da\/e..

 

Very promising stuff indeed ! Good work Pat, Pete and ScoobySport. Would like to see what a full decat SS with Ecutek on a JDM STi-7 can do

Cheers,
Ray

 

Hopefully I'll find out next week.

 

John,

Dare I saw that the Dyno chart you provided is beginning to look almost 'linear' !

For a forced induction car these sort of results will give it a bad name