Will P1 alloys fit an '03 blob STI?
11 August 2012, 06:09 PM
#1
Scooby Regular
Thread Starter
Join Date: May 2009
Location: Yorkshire
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
Will P1 alloys fit an '03 blob STI?
I have an early ('03) blobeye STI and I'm thinking of buying some P1 alloys (which I have always rather liked). I believe the PCD is 5x100 so that's fine but I don't know whether the offset (which I believe is ET53) is all right.
Can anyone enlighten me?
Can anyone enlighten me?
11 August 2012, 06:14 PM
#2
I dont think that the P1 alloys will clear the brembos, I think you need a 5mm spacer AFAIK 
Then again my BBS wheels that I have are a ET53 and they clear my brembos, Are you sure the P1's are ET53 and not ET48
Then again my BBS wheels that I have are a ET53 and they clear my brembos, Are you sure the P1's are ET53 and not ET48
Last edited by The Pink Ninja; 11 August 2012 at 06:17 PM.
11 August 2012, 07:30 PM
#3
Scooby Regular
Thread Starter
Join Date: May 2009
Location: Yorkshire
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
If they are all the same they are ET53 as I saw it stamped on the side of one on a picture on another site.
I don't fancy using spacers without understanding the implications of doing so and since the auction ends at 01:30 tomorrow I'll pass on that but thank you for the reply.
I don't fancy using spacers without understanding the implications of doing so and since the auction ends at 01:30 tomorrow I'll pass on that but thank you for the reply.
Thread
Thread Starter
Forum
Replies
Last Post