Disk change advise - urgent
#1
Disk change advise - urgent
Weather permitting I'm going to change the disks and pads this morning.
Can you tell me whether I need to clean the disk surface prior to fitting (emery cloth/ wet and dry)?
Also the caliper bolt torque (Brembo) and wheel nut torque.
Thanks
Howard
Can you tell me whether I need to clean the disk surface prior to fitting (emery cloth/ wet and dry)?
Also the caliper bolt torque (Brembo) and wheel nut torque.
Thanks
Howard
#4
Scooby Regular
Join Date: Oct 2003
Location: East Yorkshire
Posts: 1,966
Likes: 0
Received 0 Likes
on
0 Posts
According to Alyn and the 04 STi manual the torque for the Brembo caliper bolts is 114ft-lb. He considers this excessive and recommends 75ft-lb (102Nm). He says he uses this figure on grp N cars he prepares and hasn't had any problems. I use a bit of medium threadlok for peace of mind. The 68Nm above is for the Subaru OE caliper but should be 80Nm(59 ft-lb). Wheel nuts 65ft-lb (90Nm). Did a mates STi discs recently and found the caliper bolts very tight to get off - needed to use a 4lb club hammer and a ring spanner to dislodge.
Last edited by D1CCY; 03 July 2007 at 01:14 PM. Reason: found correct numbers
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM