SO-3's 16" What PSI?
31 May 2001, 08:18 PM
#2
Scooby Regular
Join Date: Jul 2001
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
Well im new to scooby ownership and no expert but id say run them at the recommended levels, read some of the above posts and youl get an idea (actually dont you have a sticker on your drivers door pillar giving pressures?, think i do)
anyway, what I really wanted to say is.. What are the S03's like? have you upgraded from S02's? are they better? and have u got a pic of the tread pattern, havnt seen them yet.
cheers
Leon
anyway, what I really wanted to say is.. What are the S03's like? have you upgraded from S02's? are they better? and have u got a pic of the tread pattern, havnt seen them yet.
cheers
Leon
01 June 2001, 04:59 PM
#4
Scooby Regular
Join Date: Nov 1999
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Ian, i am using so3's, and have upped the pressure i used to run on the toyos. try 34 front and 32 rear, seems to be an improvement for me as I was getting lots of tyre squirm at lower pressures.
Mark
Mark
02 June 2001, 01:30 AM
#5
Scooby Regular
Join Date: Feb 1999
Posts: 2,271
Likes: 0
Received 0 Likes
on
0 Posts
This is a reasonable combination.
I find that if the fronts are about 2/3 higher than the rear this works ok
I use 32 front and 30 rear. But if I'm on a booze run they get put up to 33 front 31 rear
I find that if the fronts are about 2/3 higher than the rear this works ok
I use 32 front and 30 rear. But if I'm on a booze run they get put up to 33 front 31 rear
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
14
25 September 2015 02:33 PM
aaron_ions
General Technical
1
17 September 2015 10:42 AM
Richard Gledhill
ScoobyNet General
3
19 January 2001 09:54 PM