Bedding in process for new brake pads
#1
Bedding in process for new brake pads
I am about to fit some new DS2500 pads to my MY99 and have been told no hard braking for the first few hundred miles etc etc...
Can anyone please tell me if there is an actual bedding in process for a new set of front pads ?
Regards
ste
Can anyone please tell me if there is an actual bedding in process for a new set of front pads ?
Regards
ste
#3
Hello,
We have a fairly detailed bedding in procedure documented on our web site at the end of our installation manuals. You can go to the following link and go all the way to the end... pages 19 and 20.
http://www.stoptech.com/installation...2005-12-03.pdf
Good luck.
We have a fairly detailed bedding in procedure documented on our web site at the end of our installation manuals. You can go to the following link and go all the way to the end... pages 19 and 20.
http://www.stoptech.com/installation...2005-12-03.pdf
Good luck.
#4
Scooby Regular
different manufacturers have totally different requirements so make sure you take note of their specific instructions.......................Ferodo normally include a small leaflet, from memory 25-30 short sharp stops at around 50% braking effort is required...............
** do not do any harsh "bedding" procedures if new discs are installed at same time!!
cheers, alyn - asperformance.com
** do not do any harsh "bedding" procedures if new discs are installed at same time!!
cheers, alyn - asperformance.com
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM