Which discs for track days
#2
Scooby Regular
when you say "fade" exactly what were your symptoms?? unusual for discs alone to be an issue, there will more likely be an other issue to rectify also.........
alyn - asperformance.com
alyn - asperformance.com
#3
Scooby Regular
Join Date: Sep 2001
Location: Lovely Branksome
Posts: 204
Likes: 0
Received 0 Likes
on
0 Posts
[Flame suit on]
I use Godspeed standard size bells and disc's (drilled and grooved) and standard Mintex £38 pads with standard Scooby 4 pots.
On Alyn's advice I flushed the system through with fresh dot 5 after having the brake pedal hit the floor board's.
The pads have lasted nine laps of Castle Combe with wifey behind the wheel, 1500 hard road miles and a long hard day at Keevil airfield,all with no fade and a solid pedal.
[Flame suit off]
Hope this helps
Dave
[Edited by dave_the_B - 9/21/2003 8:17:06 PM]
I use Godspeed standard size bells and disc's (drilled and grooved) and standard Mintex £38 pads with standard Scooby 4 pots.
On Alyn's advice I flushed the system through with fresh dot 5 after having the brake pedal hit the floor board's.
The pads have lasted nine laps of Castle Combe with wifey behind the wheel, 1500 hard road miles and a long hard day at Keevil airfield,all with no fade and a solid pedal.
[Flame suit off]
Hope this helps
Dave
[Edited by dave_the_B - 9/21/2003 8:17:06 PM]
#4
I had Mintex 1155 pads on Subaru 4pots with standard discs and got bad fade on track. Swapped just the pads to Pagid RS15s and got no fade, although I did manage to put a 1mm crack from the centre to the rim of one of the discs!
Swapped to a set of groupN discs (same setup as AS Performances hire rally car apparently) but never tried them on track so can't say how good they were!
Edited to say that the Mintex pads and standard discs came off another car so may not have been bedded in properly by the previous owner!
[Edited by ZAZ - 9/23/2003 5:05:28 PM]
Swapped to a set of groupN discs (same setup as AS Performances hire rally car apparently) but never tried them on track so can't say how good they were!
Edited to say that the Mintex pads and standard discs came off another car so may not have been bedded in properly by the previous owner!
[Edited by ZAZ - 9/23/2003 5:05:28 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM