Tein Mono Flex - Advice to measure P.C.D
#1
Tein Mono Flex - Advice to measure P.C.D
Hi,
After speaking to the very knowledgable Simon at Chevron Motor Sports, I'm considering Tein mono flex coilovers for my 07 STI Type UK and need to find out the PCD of my Prodrive 18's, which are a 5 bolt design.
I think it's 114mm but can someone confirm that I measure the PCD by measuring between the centre of two adjacent wheel nuts, on a 5 bolt design.
Cheers,
Steve.
And if anyone has experience of these coilovers, it would be great to hear back from you.
After speaking to the very knowledgable Simon at Chevron Motor Sports, I'm considering Tein mono flex coilovers for my 07 STI Type UK and need to find out the PCD of my Prodrive 18's, which are a 5 bolt design.
I think it's 114mm but can someone confirm that I measure the PCD by measuring between the centre of two adjacent wheel nuts, on a 5 bolt design.
Cheers,
Steve.
And if anyone has experience of these coilovers, it would be great to hear back from you.
#2
Scooby Senior
iTrader: (3)
Join Date: Jun 2006
Location: Slowly rebuilding the kit of bits into a car...
Posts: 14,333
Likes: 0
Received 0 Likes
on
0 Posts
Yes it is 114.3mm, but that is the diameter of a circle that passes through the centre of all five of the wheel nuts.
dunx
dunx
Last edited by dunx; 28 May 2010 at 05:54 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM