danmickread

Hi,

I am interested in lowering my 2000 impreza.
I am not looking for racing quality suspension, just a better look and with a bit better handling. I would like to lower by 30-40 mm. Would just changing the springs be sufficient, this would give the look i want and obviously slightly stiffer suspension anyway due to the lowering springs being slighty stiffer than stock.
If so, could anyone recommend particular makes.

Anyones opinions on this would be appreciated.

Thankyou.

stabb

Bump that up i was gonna ask more or less same.

Anybody...

would be much appreciated.

Jason.

911

IMHO:
If you want a simple tweek to your cars:

1
Fit a Whiteline rear roll bar (22mm)
2
Fit Eibach lowering springs all round
3
Fit camberbolts all round
4
Have it aligned by someone realy good, ie Powerstation's Curtis.

That added up is not too expensive, and you need the alignment anyway after the spring change.

You will be pleased with the looks, but amazed at how well it will drive.

Hope that helps.

Graham

Fuzz

Eibachs will only lower it 25-30mm at a push though..

Not sure of any lowering springs that will go that far.

AST's will


Andy

stabb

thanks for reply's

was looking to go a tad lower than an inch or so and how much would one be looking for that little lot 911 put down ?

thanks again

Jason.

Fuzz

22mm rear bar is about £100

Eibachs I "THINK" are £180

camber bolts might not be needed but maximum of two required at £22 each

Alignment £70

Andy

Fuzz

and I just noticed it's a classic so change the alignment price to £140 and have the bumpsteer done as well.


Andy