Gauging Interest - Brand new forged CDB. Cosworth, ACL ect...
#1
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Jul 2008
Location: merseyside
Posts: 408
Likes: 0
Received 0 Likes
on
0 Posts
Gauging Interest - Brand new forged CDB. Cosworth, ACL ect...
Gauging interest on an engine I have.
Its just the bottom end and is freshly assembled but never fired or ran in.
Spec as follows.
2.0 CDB with under piston oil squirters.
Converted to rear thrust. Block faces freshly skimmed
Bore & Hone to 93mm
93mm Cosworth Forged Pistons
Forged H Beam rods with ARP bolts
75mm Crank
ACL Race Bearings main & big end
Comes complete with 11mm high tensile head studs with larger washer upgrade.
Machine work cost £600 alone.
£2,450.
I am away at the moment but block would be available late December/January
Its just the bottom end and is freshly assembled but never fired or ran in.
Spec as follows.
2.0 CDB with under piston oil squirters.
Converted to rear thrust. Block faces freshly skimmed
Bore & Hone to 93mm
93mm Cosworth Forged Pistons
Forged H Beam rods with ARP bolts
75mm Crank
ACL Race Bearings main & big end
Comes complete with 11mm high tensile head studs with larger washer upgrade.
Machine work cost £600 alone.
£2,450.
I am away at the moment but block would be available late December/January
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM