drewtts

iTrader: (24)

I've 3 sets of EJ25 casings that's been closed decked all on std bore
£650-set



Drew

beliblisk

iTrader: (16)

Do they happen to have 14 mm holes for head studs?

drewtts

iTrader: (24)

They on std 11mm

beliblisk

iTrader: (16)

Are these Ej257 cdbs or normal odb from legacy........dont know if there is any differenve in the liners thicness?

drewtts

iTrader: (24)

2 sets were 257 the other was wrx 255 no difference now close decked

Wayne STI

iTrader: (1)

Hi mate - couple of stupid questions....

What power do you think these can take if keeping the 11mm studs?

I assume they can be re-bored / honed / converted for 14mm studs on demand after the inserts are fitted (I hear that the inserts are only interference fitted - will this be OK during the machining process etc)?

Sorry if that sounds a bit thick

Pricey

iTrader: (7)

I had a set of these off Drew, had some machining done and no issues with the inserts.

drewtts

iTrader: (24)

Hi Wayne they not stupid questions, yes the interferance fit and yes they can be honed (which is advisory) rebored and converted to 14mm studs no problem.
11mm studs would be the weak point on a high power build but theres no figure carved in stone what they can take I'm running prob 600 with the exact same block but on 14mm studs

drew

pot1175

iTrader: (14)

Bargain price, for some great engineering work.

drewtts

iTrader: (24)

cheers mate

drewtts

iTrader: (24)

Ive had another set of casings converted which are ready for collection tomorrow

£650