Ej25 cdb
I've 3 sets of EJ25 casings that's been closed decked all on std bore
£650-set http://i26.photobucket.com/albums/c1...t/606E68AE.jpg Drew |
Do they happen to have 14 mm holes for head studs?
|
They on std 11mm
|
Are these Ej257 cdbs or normal odb from legacy........dont know if there is any differenve in the liners thicness?
|
2 sets were 257 the other was wrx 255 no difference now close decked
|
Hi mate - couple of stupid questions....
What power do you think these can take if keeping the 11mm studs? I assume they can be re-bored / honed / converted for 14mm studs on demand after the inserts are fitted (I hear that the inserts are only interference fitted - will this be OK during the machining process etc)? Sorry if that sounds a bit thick :) |
I had a set of these off Drew, had some machining done and no issues with the inserts.
|
Originally Posted by Wayne STI
(Post 10857322)
Hi mate - couple of stupid questions....
What power do you think these can take if keeping the 11mm studs? I assume they can be re-bored / honed / converted for 14mm studs on demand after the inserts are fitted (I hear that the inserts are only interference fitted - will this be OK during the machining process etc)? Sorry if that sounds a bit thick :) Hi Wayne they not stupid questions, yes the interferance fit and yes they can be honed (which is advisory) rebored and converted to 14mm studs no problem. 11mm studs would be the weak point on a high power build but theres no figure carved in stone what they can take I'm running prob 600 with the exact same block but on 14mm studs drew |
Bargain price, for some great engineering work.
|
Originally Posted by Pricey
(Post 10857329)
I had a set of these off Drew, had some machining done and no issues with the inserts.
cheers mate |
Ive had another set of casings converted which are ready for collection tomorrow
£650 |
All times are GMT +1. The time now is 05:34 PM. |
© 2024 MH Sub I, LLC dba Internet Brands