Richardw

Just about to get the side skirts and rear spats colour coded but a few probs last night trying to get the corner/rear spats off.

Can anyone advise how these blasted things come...Ive removed the back clip + the small bolt in the front end of the bumper in the wheel arch. I noticed two additional clips underneath fastened by flat posi screws and one of these has an access hole but the other looks virtually impossible to get at.

Do I need to remove these two screws or just loosen them off - If so how to do i get to the one near the front ( about 6 inches back from the wheel arch )?

Or should they just slide off in some direction without any tampering?

or am i missing the plot completely !??

Ta in advance for any help.

Cheers
Rich

alcazar

iTrader: (2)

Once you've undone the two clips you mention, they slide off towards the rear of the car.
Alcazar

Richardw

Hi Alcazar

Do you mean the two clips which are a bugger to get at..i.e. the ones in the middle underneath ( one through the access hole and the other one i havent got a clue how to get to )


Cheers
Rich

alcazar

iTrader: (2)

No, IIRC, it's just the clips that are easy to see, hang on a minute while I go out and look at the car.......................
right, mine appears to be a bolt at the front leading edge, and a clip under the back edge, and IIRC, it was just those two.
They were stiff to pull back as they were very dirty inside.
Alcazar

Richardw

cool..I shall give it a good yank later
cheers for your help.

lordharding

iTrader: (1)

Give them a hard tap back !1

Richardw

Sorted! Only took five minutes ...getting the spats off that is! Cheers for input folks.