clifford concept 300-unable to disarm!!!!!!
25 July 2003, 12:40 PM
#1
Scooby Regular
Thread Starter
Join Date: Nov 2002
Posts: 101
Likes: 0
Received 0 Likes
on
0 Posts
Some times my remote controlls won't dissarm the alarm, which is a right pain cos I have my locks filled in so cant get in the car!
Have tried new batteries etc but usually it's just a time thing then it sorts itself out.
Could it be the reciever in the car or something else not the remotes? would be gratefull of any help cheers higgy
Have tried new batteries etc but usually it's just a time thing then it sorts itself out.
Could it be the reciever in the car or something else not the remotes? would be gratefull of any help cheers higgy
25 July 2003, 02:19 PM
#2
Scooby Regular
iTrader: (3)
Join Date: Aug 2000
Location: 1600cc's of twin scroll fun :)
Posts: 25,565
Likes: 0
Received 2 Likes
on
2 Posts
These alarms come with a limited life time warranty, it could be that your remote is on the blink (i take it you have tried both?) so the next best thing would be to reset the remote and reprogramme (id take it to a clifford dealer as its alot less hassle 
)
Cheers!
Tony
)Cheers!
Tony
25 July 2003, 07:50 PM
#3
I had a similar problem with mine. take a close look at
the 'clip' that holds the battery in (think it is soldered to
the board in three places) - mine had a 'dry' joint on one leg.
My fitter said it was not an uncommon problem !!
Or could it be just were you park it? its know that some
transmitters interfere with alarms.....
alan
the 'clip' that holds the battery in (think it is soldered to
the board in three places) - mine had a 'dry' joint on one leg.
My fitter said it was not an uncommon problem !!
Or could it be just were you park it? its know that some
transmitters interfere with alarms.....
alan
Thread
Thread Starter
Forum
Replies
Last Post