Its bloody hard LOL

using a hairdryer in places but not much help, even in this hot weather it just breaks off in strips rather than big segments, a long night ahead for me, huf LOL

Any advice for removing the stuff easy ? like soaking the bonnet in petrol and burning it all off :-)

 

Yea the petrol thing would be goin a tad over the top .
Kinda reminds me of stripping the house of woodchip in the 80's
You just gota crack on RIG

 

Heat gun , as the hairdryer isnt hot enough.

 

I have done this m8 and a heat gun works best wean you get a lip up on it just heat up and lift bit buy bit m8 good luck

 

Are you referring to fake carbon look vinyl?

 

Deffo need a heat gun.

 

cheers guys, surely a heat gun is too hot, i mean, 350 degrees, im going to burn my paint LOL, i have a heat gun, any tips, keep it far away and all that ?!?!

 

Keep it moving while pulling the vinyl and the paint wont have to take the heat very long.

 

I've seen wrap removed at www.pwpro.co.uk with a steam hand held gun. came off dead easy from a R8

 

well, i have half off with the hairdryer so will give the heat gun a go in the morning, oh god LOL !!!!!

 

you'll burn your paint work!!

 

watched a couple of pro's doing it
get a water spray bottle and fill with boiling water get a corner up and keep spraying behind while peeling

 

Cheers for the input guys, eventhe pro`s would struggle with this one, its been on 7 yrs + and is very brittle, im using a combination of heatgun and an old CD to remove it all , very time consuming but getting there, only 1 corner patch to go, all in about 5 hrs to remove it once im done, thats with buffing the bonnet as well to remove glue residue etc.