The Rig

iTrader: (13)

Its bloody hard LOL

using a hairdryer in places but not much help, even in this hot weather it just breaks off in strips rather than big segments, a long night ahead for me, huf LOL

Any advice for removing the stuff easy ? like soaking the bonnet in petrol and burning it all off :-)

jazzyjembreaze

iTrader: (11)

Yea the petrol thing would be goin a tad over the top .
Kinda reminds me of stripping the house of woodchip in the 80's
You just gota crack on RIG

CharlySkunkWeed

iTrader: (7)

Heat gun , as the hairdryer isnt hot enough.

scoobyman2007

iTrader: (5)

I have done this m8 and a heat gun works best wean you get a lip up on it just heat up and lift bit buy bit m8 good luck

mrmadcap

Are you referring to fake carbon look vinyl?

MattyB1983

iTrader: (51)

Deffo need a heat gun.

The Rig

iTrader: (13)

cheers guys, surely a heat gun is too hot, i mean, 350 degrees, im going to burn my paint LOL, i have a heat gun, any tips, keep it far away and all that ?!?!

CharlySkunkWeed

iTrader: (7)

Keep it moving while pulling the vinyl and the paint wont have to take the heat very long.

salsa-king

I've seen wrap removed at www.pwpro.co.uk with a steam hand held gun. came off dead easy from a R8

The Rig

iTrader: (13)

well, i have half off with the hairdryer so will give the heat gun a go in the morning, oh god LOL !!!!!

salsa-king

you'll burn your paint work!!

Dave-W-

iTrader: (10)

watched a couple of pro's doing it
get a water spray bottle and fill with boiling water get a corner up and keep spraying behind while peeling

The Rig

iTrader: (13)

Cheers for the input guys, eventhe pro`s would struggle with this one, its been on 7 yrs + and is very brittle, im using a combination of heatgun and an old CD to remove it all , very time consuming but getting there, only 1 corner patch to go, all in about 5 hrs to remove it once im done, thats with buffing the bonnet as well to remove glue residue etc.