Hks adaptor
#6
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Mar 2013
Location: Scottish Borders
Posts: 296
Likes: 0
Received 0 Likes
on
0 Posts
I have an adaptor from eBay which fits bolts to the tmic but I thought after reading it needs to be angled or it hits the manifold?
Mines is flat and doesn't angle the bov away ill get a pic
Is yours angled at all?
Mines is flat and doesn't angle the bov away ill get a pic
Is yours angled at all?
Trending Topics
#10
Mine looks just like that one too... Takes a bit of fiddling to get it into a position where it will fit, but mine went on fine. Here's a pic of mine just after I got it in a position where it would fit... Mine's on a 2002 WRX wagon
#12
fitted it without removing anything... Just took a few attempts to get the angle right and just meant I had to use a spanner, rather than a socket, to tighten the nut on the right hand side
#14
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Mar 2013
Location: Scottish Borders
Posts: 296
Likes: 0
Received 0 Likes
on
0 Posts
well mine didnt fit, if you look at donthaveascoobie's pic where the circlip fits his is raised, mine isnt
which means to get the ssqv sitting right the small bolts on the ssqv would hit the adaptor and make it sit squint meaning the circlip wont go on
i ended up grinding a channel out between the right hand side bolt and the center hole
very close to the manifold as well but fits now
so unless you fancy some grinding, id buy a one like the above picture and nopt a flat one like mine
which means to get the ssqv sitting right the small bolts on the ssqv would hit the adaptor and make it sit squint meaning the circlip wont go on
i ended up grinding a channel out between the right hand side bolt and the center hole
very close to the manifold as well but fits now
so unless you fancy some grinding, id buy a one like the above picture and nopt a flat one like mine
#16
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Mar 2013
Location: Scottish Borders
Posts: 296
Likes: 0
Received 0 Likes
on
0 Posts
the valve has to sit horizontaly across the adaptor, if your adaptor hasnt got a raised bit for the circlip to sit in the small bolts on the valve itself will stop it from seating correctly in the adaptor
you cant turn the valve vertically as it will hit the manifold then
Thread
Thread Starter
Forum
Replies
Last Post
bluebullet29
General Technical
9
05 October 2015 02:17 PM
Pro-Line Motorsport
Car Parts For Sale
2
29 September 2015 07:36 PM