Bananawasp

What brake are yellow sti injectors good for on a 1993 classic I have supporting mods, just wondering what they will max out at?

Bananawasp

Someone must have a little bit of an idea

deepy

iTrader: (1)

There's a table here which gives values running at 100% which isnt recommended. Around 80% of those values is about right. I guess the injectors you have are 440's

http://www.scoobypedia.co.uk/index.p...rFromInjectors

Bananawasp

I was told they were 440cc when I bought them.

deepy

iTrader: (1)

Then they will max out at around 320, but I'm sure you'll see others on here have made more/less depending what pressure they're running at.

joz8968

iTrader: (13)

From what I've gleaned on here, between 325-340 odd - at std 3bar set pressure.

Depends how 'lucky' you are.

But always plan around the worst figure - that way it'll help in deciding whether you need to 'trade up' to 550cc or greater...

Which turbo/IC combo do you plan to use?

Bananawasp

My turbo has been upgraded but I'm not sure what model it is I no its and ihi and it's huge there is no model number marked on it. Its a lot bigger than a standard td05 the problem I have at the moment is the previous owner didn't plan the mods well and I'm left to pick up the pieces!!!

He done the usual full decat, bigger turbo, air filter then a plug in Ecu chip, he melted pistons and all sorts I have rebuilt the engine with forged pistons, stronger rods, apexi Ecu so it can now take quite a bit power and Im hopefully getting it mapped by jolly green monster on Friday, I'm just wanting to make sure that I get the most out of its remap. I bought the yellow injectors hoping they would be better but it look like I should have went bigger!!!

I just have a standard top mount intercooler I have heard on here ther good for about 350-370 I'd like to get it there if I can!!

deepy

iTrader: (1)

If it's that much of a monster then 440's are most likely going to be too small. I'm sure JGM will give you best advice on what will suit your car injector or turbo wise.

P1Drifter

iTrader: (7)

if it has IHI stamped on it, it will be a VF turbo of some description, you need to identify which to be of any help, i would suggest you look for a set of 550's if i were you (good for around 380) If you have the standard slanty top mount intercooler, that really needs to be changed, they struggle at the best of times, either upgrade to a later type intercooler or go front mount.

joz8968

iTrader: (13)

Oops! Complete and utter brain fade!!!

TD is a Mitsubishi turbo!

I have therefore deleted my post.... 'cause it was bollox!

P1Drifter

iTrader: (7)

joz8968

iTrader: (13)

I think I need to lie down for a bit............

Jolly Green Monster

iTrader: (4)

biggest restriction is the slanty top mount intercooler

Bananawasp

Where is the best place for a front mount intercooler and what should I expect to pay?

Jolly Green Monster

iTrader: (4)

japspeed, harvey for a hdi, autobahn

dynamix

iTrader: (3)

probably the front of the car behind the bumper


sorry couldnt resist lol

440cc injectors max at 340-350 bhp depending on the rest of the car set up but as said the slanty top mount will restrict it most.

Bananawasp

I think I will have to wait till pay day for a front mount I don't have the money at the min my other bits and pieces have set me back 1k.