seanbaldacchino

iTrader: (3)

I have done a reverse inlet, stainless headers, light weight flywheel, light crank pulley, apexi boost control kit. I have done all of these mods all in one hit but its running ok but seems to have an Erratic Idle and a slight misfire. Just wondered if anyone had an ideas what could be causing it.

chrisdicko

iTrader: (21)

Have you had it mapped? If not, that's your problem.

Harryr34

iTrader: (9)

Could be a leak around the inlet manifold, vac pipes, IC pipework.... Also check the timing, mine had an erratic idle when one of the exhaust cams was a tooth out.

FurballPhil

Mine also had the idle problem... Would sit at 1500rpm... Then sometimes would just Rev up to 2500rpm, then drop, then up again....

Since My Re-Map @ Andy Forrest on Monday, it`s all cured.... No Rev, Idle Issues At All Now

seanbaldacchino

iTrader: (3)

Hi FurballPhil I have got exactly the same as you discribed so hoping that once its mapped it might be ok. I have got Simon coming round Tuesday so im sure he will be able to sort it out for me.
Thanks again

FurballPhil

Yep, My Car had never been a good idler since I got her over a year ago.
But now, since Monday`s Mapping she sits purring away nicely... So, I`m sure Simon will cure it.. Or at least find the root of the problem if it`s something else

richiewong

Idle control valve, MAF, Lambda?

ECU check with the connectors under the dash board.

seanbaldacchino

iTrader: (3)

ill try that, does that work on apexi power fc? Where is the best place to look for fault code diagnostics

harvey

iTrader: (48)

er.............I think you need it mapped. How can you expect it to idle properly after everything you have done without mapping it?

Midlife......

iTrader: (2)

.........you say it's running OK ? Are you actually driving it around ??

Shaun

seanbaldacchino

iTrader: (3)

yea im drivin it about. Not on boost but its not running to bad.