dawes device adjusting
#1
Scooby Newbie
Thread Starter
Join Date: May 2010
Location: oxfordshire
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
dawes device adjusting
have a dawes device on my car and the reading for boost is 0.9 at peak but most times is around 0.85 this is in mmhg so is that about 1.1 bar??
it doesnt seem to pull much with and was wondering how to adjust it and what would be the safe level to run it at on an sti engine rebuilt 10k ago, its a 94 l reg as well.
it doesnt seem to pull much with and was wondering how to adjust it and what would be the safe level to run it at on an sti engine rebuilt 10k ago, its a 94 l reg as well.
#2
Scooby Regular
iTrader: (3)
Join Date: Aug 2000
Location: 1600cc's of twin scroll fun :)
Posts: 25,565
Likes: 0
Received 2 Likes
on
2 Posts
Really your better off with an aftermarket ecu or chip that is mapped to your car, with an MBC there are too many variables to cope with, if you dont have an egt/boost/oil pressure setup and a knocklink/ks3/4 then you cannot really monitor what your car is doing.
MBC's are a little obsolesent now tbh
Tony
MBC's are a little obsolesent now tbh
Tony
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM