Forged engine components
#1
Forged engine components
Hi all,
After some forged engine internals (rods+pistons) where would be the cheapest place to get them? I am not after anything too fancy standard bore 92mm going in a open deck MY95 block. Where also can i get a decent 92mm head gasket pair too as i can only find cosworth and cometics in 93mm?
Thanks
After some forged engine internals (rods+pistons) where would be the cheapest place to get them? I am not after anything too fancy standard bore 92mm going in a open deck MY95 block. Where also can i get a decent 92mm head gasket pair too as i can only find cosworth and cometics in 93mm?
Thanks
#3
Scooby Regular
iTrader: (13)
Join Date: Sep 2005
Location: Dublin, Eire
Posts: 2,785
Likes: 0
Received 0 Likes
on
0 Posts
All head gaskets 93mm its thickness for your build to consider. as in dish volume of pistons and also your choice of head and work out compression ratio from there.
Also on a 15 year old block would advise a 0.5mm bore and hone as minimum.
Also on a 15 year old block would advise a 0.5mm bore and hone as minimum.
#4
When I recently had my 2.5 rebuilt I got all the bits from Advanced Automotive in Bristol, they were very reasonably priced and the service was spot on.
eBay UK Shop - Advanced Auto Performance Parts: Subaru performance engines and parts, Subaru Modified Uprated Oil Pump
eBay UK Shop - Advanced Auto Performance Parts: Subaru performance engines and parts, Subaru Modified Uprated Oil Pump
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM