powerwrx

iTrader: (11)

fitted some new discs and pads last week and have only done about 50miles since fitted,now my front wheels are covered in brake dust, is this normal for new pads (kevlar performance pads)

mit

iTrader: (10)

I recently fitted Mintex extreme pads, they're really bad too!

powerwrx

iTrader: (11)

im wondering if its just a phase seen as they are new

mit

iTrader: (10)

I think they'll do it till their dead im afraid.

V555MAC

iTrader: (4)

My EBC Redstuff's cover my wheels every journey!!, really pi**es me off

JohnD

iTrader: (5)

Obviously, new pads/discs will produce more initial dust as they bed-in. My DBA discs/DS2500 pads are the same at the moment. I hope it will get less as I've only done about 60 miles on them, so far. Some pads naturally produce more dust throughout their life.

JohnD

ALi-B

iTrader: (1)

Your damned either way: Pads that are less dusty tend to put out more metal debris instead (i.e wearing the disc, as well as metal content in the pad itself)...

Which ends up ingrained and embedded in the wheels as extremely hard black particles that needs agressive chemicals/polishing to remove....give me dust any day

RA Dunk

They dont look too bad to me ive seen worse, without changing the pads again your pretty fecked, get some poorboys wheels sealant and give your wheels a few coats, will make them alot easier to clean

powerwrx

iTrader: (11)

i think they are bad enough seen as ive only been out in the car 3 times since fitting them with no hard braking either