Wiring up gauges help please
#1
Guest
Posts: n/a
Wiring up gauges help please
Hello peoples
I need help wiring in 2 gauges
I already have the power suplpy sorted just the rest i need - They are going on the drivers pillar
1x Air/fuel ratio gauge
And one of these guages - Where is the sensor it goes into or is that pish (havent bought this one yet)
DIGITAL OIL PRESSURE GAUGE - BAR display on eBay, also Other Performance Parts, Performance Tuning Parts, Car Tuning Styling, Cars, Parts Vehicles (end time 02-May-09 09:52:43 BST)
I need help wiring in 2 gauges
I already have the power suplpy sorted just the rest i need - They are going on the drivers pillar
1x Air/fuel ratio gauge
And one of these guages - Where is the sensor it goes into or is that pish (havent bought this one yet)
DIGITAL OIL PRESSURE GAUGE - BAR display on eBay, also Other Performance Parts, Performance Tuning Parts, Car Tuning Styling, Cars, Parts Vehicles (end time 02-May-09 09:52:43 BST)
#3
Connor
Your AFR needs to use the lambda sensor output wire. The oil gauge will come with a calibrated sensor that you need to fit (you wont be able to take a feed from an OE one as it wont have the same calibration as your gauge).
Look here
Muddy's Web site - The No. 1 site for The Subaru Impreza Turbo
HTH
Your AFR needs to use the lambda sensor output wire. The oil gauge will come with a calibrated sensor that you need to fit (you wont be able to take a feed from an OE one as it wont have the same calibration as your gauge).
Look here
Muddy's Web site - The No. 1 site for The Subaru Impreza Turbo
HTH
#6
afr guage
if i remember correctly if you pull apart the connecter to the lamda sensor,(front left of engine conpartment by airbox) there is a different coloured connector from the rest, identify which wire this goes to and splice into that one this will give you your reading for your afr, hope this helps
Thread
Thread Starter
Forum
Replies
Last Post