HKS EVC ERROR CODES
#1
Scooby Regular
Thread Starter
Join Date: Jun 2003
Location: Founder of surreyscoobies.co.uk
Posts: 2,889
Likes: 0
Received 0 Likes
on
0 Posts
HKS EVC ERROR CODES
Stopped and filled up with petrol tonight and after starting her up again the boost controller displayed "error 100" for the rest of the trip home, upon applying throttle there were a series of beeps but i only had stock boost, no matter what buttons i pressed it would not go away
Once i got home and switched the ignition off then on again it cleared then it happened again a few seconds later, I then unplugged the stepping motor and and the error message changed to "error 001", plugged it all back in again and took it down the road and all "seems" to be fine
I cannot read the manual as its in Japanese, anyone had the same happen?
andy
Once i got home and switched the ignition off then on again it cleared then it happened again a few seconds later, I then unplugged the stepping motor and and the error message changed to "error 001", plugged it all back in again and took it down the road and all "seems" to be fine
I cannot read the manual as its in Japanese, anyone had the same happen?
andy
#2
Scooby Regular
iTrader: (2)
Join Date: Sep 2002
Location: West Yorkshire
Posts: 2,977
Likes: 0
Received 0 Likes
on
0 Posts
Funny that Andy-mine did exactly the same for about five seconds on Saturday night but immediately rectified itself without switching the engine off.
Its been running fine since. My box and instructions are at Jap innovations and I'm due to pick them up when I have the fuel pump fitted in the next couple of weeks. I'll take a copy of them and send them on. Yours is the EVC V right?
I never dare fiddle with mine. Whats your boost set at now? To be honest I cant really tell the difference (low boost set to 1.0 and high boost at 1.26) from the standard settings
Its been running fine since. My box and instructions are at Jap innovations and I'm due to pick them up when I have the fuel pump fitted in the next couple of weeks. I'll take a copy of them and send them on. Yours is the EVC V right?
I never dare fiddle with mine. Whats your boost set at now? To be honest I cant really tell the difference (low boost set to 1.0 and high boost at 1.26) from the standard settings
#3
Scooby Regular
Thread Starter
Join Date: Jun 2003
Location: Founder of surreyscoobies.co.uk
Posts: 2,889
Likes: 0
Received 0 Likes
on
0 Posts
Mine seems to be ok now, maybe just a gremlin boost on low is 0.9 bar and on high is 1.27 and 1.3 on SBC, fuel cut has been eliminated too
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
crazyspeedfreakz
Wanted
17
05 October 2015 07:19 PM