blitz turbo timer boost reading
#1
I have just received my blitz turbo timer that also has boost measurement and will be fitting it tomorrow just wondering where i fit the vacuum hose to, i have a little t-pipe so the it can be attached to an existing pipe but which one? Pics would be very helpful.
Thanks
Thanks
#2
Scooby Regular
Join Date: Nov 2002
Location: esssssssex
Posts: 757
Likes: 0
Received 0 Likes
on
0 Posts
fitted mine to the boost pipe from the d/v seemed to work ok from there! not got pics here at work! if i get a chance sort some tonight around rebuilding my car!
steve
steve
#3
Scooby Regular
iTrader: (1)
Join Date: Apr 2003
Location: Glasgow, Scotland
Posts: 5,947
Likes: 0
Received 0 Likes
on
0 Posts
Don't say I'm not good to you lot!!
Here is a pic of where I fitted the t-piece into the vacuum pipe for the Blitz Boost Gauge.
The arrows indicate the route the pipe took, and I have circled the exact location of the t-piece insertion.
I fed the pipe down to the bulkhead and through a grommet near to the lambda sensor and it comes out in the footwell, near to the clutch, where you can connect it to your control module behind your dash somewhere. Be careful it doesn't touch the downpipe or turbo though, cos they'll cook it!
Here is a pic of where I fitted the t-piece into the vacuum pipe for the Blitz Boost Gauge.
The arrows indicate the route the pipe took, and I have circled the exact location of the t-piece insertion.
I fed the pipe down to the bulkhead and through a grommet near to the lambda sensor and it comes out in the footwell, near to the clutch, where you can connect it to your control module behind your dash somewhere. Be careful it doesn't touch the downpipe or turbo though, cos they'll cook it!
Thread
Thread Starter
Forum
Replies
Last Post
blockhead
Subaru Parts
19
07 November 2015 11:50 PM
hedgecutter
General Technical
3
25 September 2015 02:35 PM