URGENT - Powerap exhaust wrap
#1
Scooby Regular
Thread Starter
Join Date: Nov 2002
Location: Throwing myself down a mountain at every opportunity...
Posts: 6,794
Likes: 0
Received 0 Likes
on
0 Posts
Need to do this tomorrow, I know you need to wet some of them before application, does that also apply to the powerap stuff from rally designs??? Do you completely soak it wrap tightly then leave to dry naturally???
cheers
Ed
cheers
Ed
#4
I've recently used the stuff from RallyDesign.I did a dry run to get an idea of how much I'd need then added 6" just in case.I then rolled it back up and placed it in water for about 30 secs.
It's easier to apply(IMO)when rolled up as it's not dragging on the floor and picking up crap and will hold itself in place until you've finished and can use the steel cable ties/wire.Ideally you need 2 pairs of pliers to do this,preferably with help from a mate as the ties are quite fiddly.I mangaed mine on my own,it's just a bit tricky.
It's easier to apply(IMO)when rolled up as it's not dragging on the floor and picking up crap and will hold itself in place until you've finished and can use the steel cable ties/wire.Ideally you need 2 pairs of pliers to do this,preferably with help from a mate as the ties are quite fiddly.I mangaed mine on my own,it's just a bit tricky.
#5
Scooby Regular
Thread Starter
Join Date: Nov 2002
Location: Throwing myself down a mountain at every opportunity...
Posts: 6,794
Likes: 0
Received 0 Likes
on
0 Posts
Hmmm I think mine is more brown than white. I think I'l leave it til the AM and call rally design just to be sure.
Thanks for your comments / help
Thanks for your comments / help
Trending Topics
#9
Scooby Regular
Thread Starter
Join Date: Nov 2002
Location: Throwing myself down a mountain at every opportunity...
Posts: 6,794
Likes: 0
Received 0 Likes
on
0 Posts
I soaked mine, then pulled them through my fingers so they wet as opposed to dripping, then wrapped tight. Seems to have worked a treat!
Thread
Thread Starter
Forum
Replies
Last Post
fatboy_coach
General Technical
15
18 June 2016 03:48 PM