GAPS BETWEEN FRONT BUMPER AND FRONT WING
#1
Hi all,
I have owned 2 Classic Scoobs, im just wondering has anyone managed to get rid of the gaps mentioned above?? It looks so tacky it almost looks as though the bumpers going to come off!!!
Many thanks
I have owned 2 Classic Scoobs, im just wondering has anyone managed to get rid of the gaps mentioned above?? It looks so tacky it almost looks as though the bumpers going to come off!!!
Many thanks
#2
Twatful
Join Date: Apr 2003
Location: Grew up and don't drive Scoobs anymore!
Posts: 9,050
Likes: 0
Received 0 Likes
on
0 Posts
Got about 8mm gap on both nearside and offside. Had the bumper off but can't seem to sort out this problem without bending the supporting metal. Agree looks cack!
#3
I did have it sorted out by my subaru dealer for £135.00 !!!
They just put 4 bolts underneath the car, but to cover their backs they said "it wont stay up for long" They were right 3 months later and its down again. Someone on here must of found a way of doing it because i would say 80% of Classics have this problem.
They just put 4 bolts underneath the car, but to cover their backs they said "it wont stay up for long" They were right 3 months later and its down again. Someone on here must of found a way of doing it because i would say 80% of Classics have this problem.
#7
No mate,
i mean all the time, just below the sidelights ive got a big gap both sides!! If i get on the floor and push the whole bumper up it looks fine but i cant find anything to mount it to??
i mean all the time, just below the sidelights ive got a big gap both sides!! If i get on the floor and push the whole bumper up it looks fine but i cant find anything to mount it to??
Trending Topics
#12
Scooby Regular
Join Date: Apr 2002
Location: Norhtumberland
Posts: 394
Likes: 0
Received 0 Likes
on
0 Posts
Not found a cure yet, i have the sti 6 front bumper on mine and thought it was just that but it must happen to most, does look w@nk.
Sy
car still looks fab tho.
Sy
car still looks fab tho.
#14
I've recently replaced my front bumper, and it sits perfectly. I think it may just be a case of a loose bolt here and there. If it sits properly when you support it then that may well be the case.
There are 4 17mm bolts that hold the bumper hanger on under the bonnet. 2 infront of the battery and 2 by the abs unit. Give them a tighten. Also tighten up the 2 bolts that should be underneath wher the foglights are. when I first put the skin back on I missed theses ones off and it did look like it was hanging a bit too low.
There are 4 17mm bolts that hold the bumper hanger on under the bonnet. 2 infront of the battery and 2 by the abs unit. Give them a tighten. Also tighten up the 2 bolts that should be underneath wher the foglights are. when I first put the skin back on I missed theses ones off and it did look like it was hanging a bit too low.
Thread
Thread Starter
Forum
Replies
Last Post
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM
Sub-Subaru
General Technical
1
28 September 2015 12:47 PM