Removing orange things below indicators
#2
Scooby Regular
Join Date: Sep 2000
Location: Deepest Darkest Dorset!!
Posts: 10,011
Likes: 0
Received 1 Like
on
1 Post
1. Get flat blade screwdriver.
2. Insert at top of 'orroble orange thingies'
3. Press down, and at the same time sort of pull forward. They should come out without too much fuss.
Ron
2. Insert at top of 'orroble orange thingies'
3. Press down, and at the same time sort of pull forward. They should come out without too much fuss.
Ron
#3
I just got a pair of pliers and pulled and they came off really easy.
Two options from there - use paint stripper to remove the orange paint as they are black underneath or spray over the top.
ChrisB.
Two options from there - use paint stripper to remove the orange paint as they are black underneath or spray over the top.
ChrisB.
#7
Just Do what I did.
Go to a friends house with a narrow drive.......
But you'll have to get the front bumper resprayed and buy a new side light lens............
[This message has been edited by neveryoumind (edited 14 September 2001).]
Go to a friends house with a narrow drive.......
But you'll have to get the front bumper resprayed and buy a new side light lens............
[This message has been edited by neveryoumind (edited 14 September 2001).]
Trending Topics
#9
Dave,
done this about 4 months ago, the my2000 requires 1 screw to fix the front indicators, take that out, drop the indicator, then push the orrible orange things out from behind. re-spray them...leave em for a few hours to dry, then pop em back in.
you dont risk damage to other paintwork around area etc by having to lever or pull them then!
my dbm is now nicely co-ordinated, but it just leads to the next project...(the horn was a good one!)
rob
done this about 4 months ago, the my2000 requires 1 screw to fix the front indicators, take that out, drop the indicator, then push the orrible orange things out from behind. re-spray them...leave em for a few hours to dry, then pop em back in.
you dont risk damage to other paintwork around area etc by having to lever or pull them then!
my dbm is now nicely co-ordinated, but it just leads to the next project...(the horn was a good one!)
rob
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM