wj52lee

Guys
Bit off info needed if any of ya hase any experience with these.
Just finished a 2.1 useing these pistons, never used these before always been on 4032's, anyway cant get her to fire up. Wandering if these are hard to get started for the first time?

merlin24

iTrader: (1)

Piston are very good - have used around 6 set's of the 2618 Grade Mahle's with no problems at all.
Very unlikely the piston's will be the cause of the non start tbh.

Mick

wj52lee

Thanks mick
Not to sure whats goin on with her, couldnt get her to kick so tore her back down to tripple check everything and found more oil than im used to in the bores. Was thinking due to the extra clearence the pistons run they may take a bit of starting to get some compression out of them

wj52lee

AS Performance

iTrader: (4)

we pretty much exclusively use 2618's in all of our builds as well as supplying them to other builders and customers

as above the non-start has nothing to do with piston spec

there is something odd going on there with all that oil about unless you have machined them for 1/2" bore clearance???

wj52lee

Nope just bored to 92.5 for 92.5 pistons, im stumped! May have to dig into the block deeper