Sky connection advice please
#1
Scooby Regular
Thread Starter
iTrader: (46)
Join Date: Nov 2005
Location: Probably polishing it.Lol
Posts: 5,381
Likes: 0
Received 0 Likes
on
0 Posts
Sky connection advice please
Today i disconnected the sky at the back of the digibox (screw in ariel)and after reconecting things exactly the same as it was before, I now have "No satellite signal is being received" message on my tv.
I have tried a number of times fiddling about with the srew in ariel but to no avail. I have spoken with sky who have gone through their procedures over the phone but still no joy. They are sending an engineer on Tuesday but im too impatient to wait.
Can i have broken the box by disconecting the ariel or could it be something else?. The box was working fine before i interfered with it.
Any advice appreciated
I have tried a number of times fiddling about with the srew in ariel but to no avail. I have spoken with sky who have gone through their procedures over the phone but still no joy. They are sending an engineer on Tuesday but im too impatient to wait.
Can i have broken the box by disconecting the ariel or could it be something else?. The box was working fine before i interfered with it.
Any advice appreciated
#3
There is a fuse in the box that sometimes blow if you don`t unplug it from the mains before unscrewing the F conector. But if you have an on screen message the box is working and it is probably the LNB that has blown.
#4
It's very likely you've upset the connections in either or both of the F connectors. It's happened to me a few times - just disassemble them and check them out for either a short or a poor connection.
Failing that, it could well be as All Torque says - an internal fuse. It's unlikely to be your sat box.
Failing that, it could well be as All Torque says - an internal fuse. It's unlikely to be your sat box.
Last edited by maxxielives; 03 December 2006 at 09:26 PM.
#5
Scooby Regular
Join Date: May 2006
Location: I have ad blocked my rep - so dont waste your time!
Posts: 1,548
Likes: 0
Received 0 Likes
on
0 Posts
i recently re-wired mine as i moved the box around - they are very fussy and unless the f connector is just right they will easily show zero signal.
#6
Scooby Regular
Thread Starter
iTrader: (46)
Join Date: Nov 2005
Location: Probably polishing it.Lol
Posts: 5,381
Likes: 0
Received 0 Likes
on
0 Posts
For anybody that is interested it was the sky ariel.
Apparently if the internal core of the ariel touches the fine wire that coates the plastic then this will cause loss of signal.
Apparently if the internal core of the ariel touches the fine wire that coates the plastic then this will cause loss of signal.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM