** Show me your KNOCKLINKS **
Trending Topics
#12
Scooby Regular
Join Date: Feb 2002
Location: Behind the 400BHP door :)
Posts: 1,403
Likes: 0
Received 0 Likes
on
0 Posts
If you remove the cover from the KL box, you can then use the lid you removed as a template to drill out the 5 holes into the Dash clocks shroud.
Then push the KL Box onto the clock shroud, and poke the LEDS through the holes. Secure the KL box with some tape/sticky pads etc.
Refit the clock surround and......VOILA!!
The speedo/rev counter is the thing you look at the most when driving (other than the road LOL ) so makes sense to have it in that line of vision IMHO.
Then push the KL Box onto the clock shroud, and poke the LEDS through the holes. Secure the KL box with some tape/sticky pads etc.
Refit the clock surround and......VOILA!!
The speedo/rev counter is the thing you look at the most when driving (other than the road LOL ) so makes sense to have it in that line of vision IMHO.
#15
Scooby Regular
sorry not on the first date,,, pmsl
mines in the vent closest to the door in the drivers side, fits ratehr nicely, can't get a pic up tonight cos cars in the garage for a new gearbox, but to check on progress tomorrow so get a couple of snaps for you
mines in the vent closest to the door in the drivers side, fits ratehr nicely, can't get a pic up tonight cos cars in the garage for a new gearbox, but to check on progress tomorrow so get a couple of snaps for you
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Phil3822
General Technical
0
30 September 2015 06:29 PM