some nice new Mods :)
#4
BANNED
Join Date: Mar 2002
Location: LIVERPOOL THE CENTRE OF EXCELLENCE
Posts: 8,511
Likes: 0
Received 0 Likes
on
0 Posts
Nice, changed a bit since I last saw it.
Are you not bothering blankin your plate?
Mines back to legal plates at the moment, after suffering the indiginty of being pulled over by a copper on a horse!
Later Yoza
Are you not bothering blankin your plate?
Mines back to legal plates at the moment, after suffering the indiginty of being pulled over by a copper on a horse!
Later Yoza
#5
Scooby Regular
Thread Starter
cheers
not bothered with hiding the plate, loads of people have seen my car, and many more will, dont think it makes too much difference wether peeps see it on here, or see it where I live
Just need a big phat rear spoiler & tints to finish it off, oh and to get back to my PD7's
not bothered with hiding the plate, loads of people have seen my car, and many more will, dont think it makes too much difference wether peeps see it on here, or see it where I live
Just need a big phat rear spoiler & tints to finish it off, oh and to get back to my PD7's
Trending Topics
#8
Scooby Regular
Join Date: Feb 2001
Location: Hemel Hempstead
Posts: 7,953
Likes: 0
Received 0 Likes
on
0 Posts
Mines back to legal plates at the moment, after suffering the indiginty of being pulled over by a copper on a horse!
Sonic, looking good as always mate, love the new front end
#10
Scooby Regular
Thread Starter
thanks for the comments, ive now stuck my PD7's back on complete with new boots, ready for TOTB, (im not running, but I am going )
Triple X YHM
Steve
Triple X YHM
Steve
#15
Scooby Regular
Thread Starter
Yep thats right
The splitter was easy to fit, screw in each end in the wheel arch bit, and bonded the rest
The Driving Lamps I had to drill some small holes to allow the adjusters to fit through the backing plate, but again it was easy, and only took about half an hour
The splitter was easy to fit, screw in each end in the wheel arch bit, and bonded the rest
The Driving Lamps I had to drill some small holes to allow the adjusters to fit through the backing plate, but again it was easy, and only took about half an hour
#16
Scooby Regular
Join Date: Jul 2003
Location: Carlisle
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
Ahh so thats how you do it! Don't think it would fit my MY94 though. Mines a UK turbo and it badly needs a lip around the front bumper but I'm just not sure which one to put on. Any suggestions?
Thanks guys.
Thanks guys.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM