help needed dipped and hi beam both on
#1
help needed dipped and hi beam both on
Hi guys, just tried to fit HID kit which did not work, did not cut any wires tried to put standard bulb back in and dipped bulb only coming on very dim plus main beam on both sides also coming on same time as dipped beam again also dim?????
I have check postive and negative connections, fuses and relay dont know has done wrong (also tried another bulb) any know how to resolve this?
thanks
I have check postive and negative connections, fuses and relay dont know has done wrong (also tried another bulb) any know how to resolve this?
thanks
#3
yes i got a tester what do i need to check. Basically passenger side dipped works fine, driver side is on but very dim and this is causing main beam to be on but also dim
#4
Scooby Senior
iTrader: (3)
Join Date: Jun 2006
Location: Slowly rebuilding the kit of bits into a car...
Posts: 14,333
Likes: 0
Received 0 Likes
on
0 Posts
Both are dim because you are dropping 12 v across both loads, instead of feeding them separately...
HTH
dunx
P.S. pull relays out and swap over to see if one is goosed, and check all fuses.
HTH
dunx
P.S. pull relays out and swap over to see if one is goosed, and check all fuses.
Last edited by dunx; 27 December 2009 at 10:03 PM.
Trending Topics
#8
Hi Guys thanks for your help, it was the driverside headlamp fuse (looked ok ie wire not broken) swapped it for a new fuse and working again.
Now thats sorted need to fit the HID kit.
Its one of Bobs dipped beam H1 kits (trying to fit to 05 Blobeye STI), plugged everything in but bulb did not light up (red wire from hid kit to red car wiring and black wire from hid kit to black car wiring) . I know many advise to swap the wires but is there any chance of blowing anything I dont want to cause problems. Is there anything else I need to do (do the wires need to go directly to the battery as suggested by Bob or into the standard dipped beam wiring)?
Thanks guys
Now thats sorted need to fit the HID kit.
Its one of Bobs dipped beam H1 kits (trying to fit to 05 Blobeye STI), plugged everything in but bulb did not light up (red wire from hid kit to red car wiring and black wire from hid kit to black car wiring) . I know many advise to swap the wires but is there any chance of blowing anything I dont want to cause problems. Is there anything else I need to do (do the wires need to go directly to the battery as suggested by Bob or into the standard dipped beam wiring)?
Thanks guys
Last edited by bloodshotsti; 28 December 2009 at 04:55 PM.
#11
Thread
Thread Starter
Forum
Replies
Last Post
robbie1988
Wanted
2
13 September 2015 09:25 AM
Scooby-Doo 2
Wheels And Tyres For Sale
1
09 September 2015 06:51 PM