PSI3 monitor switching off
#1
PSI3 monitor switching off
I did send an email to PSI3. But have had no response. It may not have gotten through as I used a gmail account.
I have a pod mount unit in a Subaru impreza bugeye sedan wrx. It was working correctly last year. It is the version with 4 units displayed on the screen
With the engine running
It comes on with the ignition and you see the startup+welcome message.
It then says good bye and you can see only the time for a few
min. It then switches off. If you press the enter key it does this
again. (Please note it has worked correctly for the last year.)
What could be causing this? It is possible to reset the unit to defaults.
I assume the unit is getting power as it displays the time for quite a
few minutes. (with the engine running)
Regards
I have a pod mount unit in a Subaru impreza bugeye sedan wrx. It was working correctly last year. It is the version with 4 units displayed on the screen
With the engine running
It comes on with the ignition and you see the startup+welcome message.
It then says good bye and you can see only the time for a few
min. It then switches off. If you press the enter key it does this
again. (Please note it has worked correctly for the last year.)
What could be causing this? It is possible to reset the unit to defaults.
I assume the unit is getting power as it displays the time for quite a
few minutes. (with the engine running)
Regards
Last edited by silver6933; 16 January 2008 at 08:44 AM. Reason: not lcd
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM