Sti8 - changing Main Beam - How to ?
#1
Anyone got any advice on how to remove the connectors on these headlamps. The tight fit is fiddly, but that in itself wouldn't stop me getting them off. They just seem highly stubborn - is there some hidden catch ? Have tried pulling the whole black connector in most directions ... no joy.
Martin.
Martin.
#2
Scooby Regular
Join Date: Jun 2003
Location: A Shanty Town near you !
Posts: 547
Likes: 0
Received 0 Likes
on
0 Posts
I used a thin nose pair of plyers and give em a tug (oo er missus)
I also had to lift the battery outa bit so i could get my hands in there !!!
I also had to lift the battery outa bit so i could get my hands in there !!!
#3
Scooby Regular
Join Date: Oct 2001
Location: North Yorks, MY03 PPP, now run a Mondeo ST TDCI 06
Posts: 1,032
Likes: 0
Received 0 Likes
on
0 Posts
Squeeze them firmly at the back edge and pull, they will come out. The difficult bit is getting the bulbs in and out, in a very confined space!
Dan
Dan
#4
Was too timid to go down the pliers route straight off, but will give that a shot tomorrow ... efforts so for virtually pulled the bulb out with the connector :-)) though the whole assembly kind of bends where it slots into the holes in the headlamp lens.
Anyway, roll on tomorrows attempt - can't wait (not) - thanks folks.
Martin.
Anyway, roll on tomorrows attempt - can't wait (not) - thanks folks.
Martin.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Pro-Line Motorsport
Car Parts For Sale
2
29 September 2015 07:36 PM