Saalro

iTrader: (8)

the interior trim shown in the picture below on a MY00 Turbo 2000 and also how do you remove the front passenger seat, i can see there is 2 bolts at the front but on the rear bolts seem to be covered and and can't get the covers off?

http://imgs.inkfrog.com/pix/gtschris/DSC05777.JPG

Thanks a lot

joey_turbo

iTrader: (26)

start by removing the handbrake cover part of the centre console. That'll release the bit under the ashtray, and just gently pull it off from the bottom.

Saalro

iTrader: (8)

Thank you

Saalro

iTrader: (8)

Hmmmmmm how do you remove the center consol around the hand brake?

And "bump" to the front passenger seat question.

Thanks

DJ_Jon

iTrader: (7)

lift up the arm rest & there are 2 screws with caps on them, remove those. Lift the plastic handbrake trim from the rear & it will come out - disconnect the plugs for the electric mirrors to remove it fully.

The gear lever surround will just lift out from the rear.

Passenger seat - there are 2 plastic covers over the rear bolts, gently pull them rearwards to remove them - they may need some persuasion with a screwdriver.

job jobbed!

Saalro

iTrader: (8)

And before removing the seat should i be disconnecting the battery? Is there any electronics located under the seat?

Thanks

DJ_Jon

iTrader: (7)

I don't think you need to disconnect the battery. Can't remember if there are seatbelt pre-tensioners on that year. A quick look under the seat should reveal a plug.

Saalro

iTrader: (8)

Thanks a lot all.