How do you remove...
the interior trim shown in the picture below on a MY00 Turbo 2000 and also how do you remove the front passenger seat, i can see there is 2 bolts at the front but on the rear bolts seem to be covered and and can't get the covers off?
http://imgs.inkfrog.com/pix/gtschris/DSC05777.JPG Thanks a lot |
start by removing the handbrake cover part of the centre console. That'll release the bit under the ashtray, and just gently pull it off from the bottom.
|
Thank you
|
Hmmmmmm how do you remove the center consol around the hand brake?
And "bump" to the front passenger seat question. Thanks |
lift up the arm rest & there are 2 screws with caps on them, remove those. Lift the plastic handbrake trim from the rear & it will come out - disconnect the plugs for the electric mirrors to remove it fully.
The gear lever surround will just lift out from the rear. Passenger seat - there are 2 plastic covers over the rear bolts, gently pull them rearwards to remove them - they may need some persuasion with a screwdriver. job jobbed! |
And before removing the seat should i be disconnecting the battery? Is there any electronics located under the seat?
Thanks |
I don't think you need to disconnect the battery. Can't remember if there are seatbelt pre-tensioners on that year. A quick look under the seat should reveal a plug.
|
Thanks a lot all.
|
All times are GMT +1. The time now is 01:36 AM. |
© 2024 MH Sub I, LLC dba Internet Brands