Mounting a Gauge on Newage
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jul 2007
Posts: 310
Likes: 0
Received 0 Likes
on
0 Posts
Mounting a Gauge on Newage
Has anyone mounted a gauge in the air vent on the o/s?
Seems a ideal low key location without the need to have a pod shouting out to theiving scum.
Does the vent pop out, any tips as I may give it a bash to see how it looks.
Seems a ideal low key location without the need to have a pod shouting out to theiving scum.
Does the vent pop out, any tips as I may give it a bash to see how it looks.
#3
Scooby Newbie
Join Date: Feb 2009
Location: Swadlincote, Derbyshire
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Hello
Was quite interested in this idea so I did a little research. To do it properly you would need to remove the dash or at least get under it or behind it this would then enable the removal of the vent and to redirect or block off the heating duct. I have included some diagrams below:
Side Vent:
Heating Duct:
Hope this helps a little
Dan
Was quite interested in this idea so I did a little research. To do it properly you would need to remove the dash or at least get under it or behind it this would then enable the removal of the vent and to redirect or block off the heating duct. I have included some diagrams below:
Side Vent:
Heating Duct:
Hope this helps a little
Dan
Thread
Thread Starter
Forum
Replies
Last Post
supshon
General Technical
2
03 October 2015 08:06 PM